Gen V Standalone Wire Harness

***This harness must be used with a 4 WIRE Fuel Rail Pressure Sensor***

Why BP Automotive?

• GM color-coded TXL wire to meet or exceed OEM standards
• Oxygen Sensor and Crankshaft Position circuits are covered with 1200* Fiberglass Braid
• We only use OEM Aptiv (Formerly Delphi), Kostal, Bosch, Molex, and Yazaki connectors, seals, and terminals
• Connector Position Assurance Locks (CPA Locks)
• Sliding Delphi Grommet that can be positioned on the main harness line to seal your firewall.
• 5 foot long from the rear passenger side of the intake
• PCM can be mounted inside the passenger compartment or the engine bay
• OEM fuse block with all covers, labeling, and splash guards for a long-lasting weather-resistant installation

Connections Included in this Standalone Harness

• Throttle Body
• Coolant Temperature Sensor
• Alternator/Generator
• All 8 Coils
• Bank 1 and Bank 2 Injector Harness Connectors
• Bank 1 and Bank 2 Knock Sensors
• Camshaft Position Harness Connector
• 6L80e/6L90e 6 Speed Transmission Connector
• Bank 1 Upstream Oxygen Sensor
• Bank 2 Upstream Oxygen Sensor
• Multifunction Air Intake Sensor
• Crank Position Sensor
• A/C Pressure Sensor
• OBD II Port (DLC Port)
• Single Harness Ground
• Single Battery Constant Connection

Connections From Our Harness You Will Need to Hookup

• Fuel Pump (Required)
• Switched Ignition (Required)
• Brake Switch (Required)
• Malfunction Indicator (Check Engine, MIL, CEL, ETC.)
• Speedometer
• Tachometer
• Fan 1 Relay Control (Low Speed or Single Control)
• Fan 2 Relay Control (High Speed or Second Fan Control)